![[PukiWiki]](image/pukiwiki.png "[PukiWiki]")
Nonconjugated polymer dots (NPDs) were successfully used as fluorescent probes to selectively and sensitively detect picric acid (PA). The NPDs were prepared from polyethylenimine and 1,4-phthalaldehyde under mild conditions and had excitation and emission maxima of 351 and 474 nm, respectively. Fluorescence of the NPDs was efficiently quenched by PA through the inner filter effect because of the overlapping PA absorption band and NPD excitation spectrum. The NPDs allowed PA to be determined with a high degree of sensitivity. The linear range was 0-140μM and the detection limit was 0.5μM. The work involved developing a novel method for synthesizing NPDs and a promising platform for determining PA in environmental media.Plasmonic nanostructures are successfully demonstrated in solar cells due to their broad spectra-selective resonance in the range of ultraviolet to near-infrared, and thus light absorption can be mostly improved and power conversion efficiency (PCE) further. Here, we demonstrate plasmonic dye-sensitized solar cells (DSSCs) using collapsible Au nanofingers to build photoanode to enhance light absorption. In this plasmonic DSSCs, by balancing local field enhancement due to gap-plasmon resonance and dye fluorescence quenching, the optimal gap size in collapsed Au/Al2O3/Au nanofingers is designed by twice the Al2O3thickness and then deposited a TiO2layer as photoanode. The results show that the PCE of DSSCs is mostly improved as compared to DSSCs with photoanode of Au/Al2O3/TiO2films, which can be ascribed to the coupled local field enhancement within the sub-nanometer gaps. In addition, fluorescence of dyes on plasmonic nanofingers is nearly 10 times higher than plain Au/Al2O3/TiO2films, which further proves the dye absorption enhancement. These plasmonic nanofingers enable the precise engineering of gap-plasmon modes and can be scaled up to wafer scale with low cost by the nanoimprint lithography technique, which suggests the feasibility of applying our result in constructing the photoanode for other types of solar cells.Colloidal gels constitute an important class of materials found in many contexts and with a wide range of applications. https://www.selleckchem.com/products/pmx-53.html Yet as matter far from equilibrium, gels exhibit a variety of time--dependent behaviours, which can be perplexing, such as an increase in strength prior to catastrophic failure. Remarkably, such complex phenomena are faithfully captured by an extremely simple model -- ``sticky spheres''. Here we review progress in our understanding of colloidal gels made through the use of real space analysis and particle resolved studies. We consider the challenges of obtaining a suitable experimental system where the refractive index and density of the colloidal particles is matched to that of the solvent. We review work to obtain a particle--level mechanism for rigidity in gels and the evolution of our understanding of time-dependent behaviour, from early-time aggregation to ageing, before considering the response of colloidal gels to deformation and then move on to more complex systems of anisotropic particles and mixtures. Finally we note some more exotic materials with similar properties.Bone contains a dense network of blood vessels that are essential to its homoeostasis, endocrine function, mineral metabolism and regenerative functions. In addition, bone vasculature is implicated in a number of prominent skeletal diseases, and bone has high affinity for metastatic cancers. Despite vasculature being an integral part of bone physiology and pathophysiology, it is often ignored or oversimplified inin vitrobone models. However, 3D physiologically relevant vasculature can now be engineeredin vitro, with microphysiological systems (MPS) increasingly being used as platforms for engineering this physiologically relevant vasculature. In recent years, vascularised models of bone in MPSs systems have been reported in the literature, representing the beginning of a possible technological step change in how bone is modelledin vitro. Vascularised bone MPSs is a subfield of bone research in its nascency, however given the impact of MPSs has had inin vitroorgan modelling, and the crucial role of vasculature to bone physiology, these systems stand to have a substantial impact on bone research. However, engineering vasculature within the specific design restraints of the bone niche is significantly challenging given the different requirements for engineering bone and vasculature. With this in mind, this paper aims to serve as technical guidance for the biofabrication of vascularised bone tissue within MPS devices. We first discuss the key engineering and biological considerations for engineering more physiologically relevant vasculaturein vitrowithin the specific design constraints of the bone niche. We next explore emerging applications of vascularised bone MPSs, and conclude with a discussion on the current status of vascularised bone MPS biofabrication and suggest directions for development of next generation vascularised bone MPSs.Herein, we demonstrate a distinctive energy harvesting method that electricity can be generated from the ionic solution flowing through the interstices between packed three-dimensional graphene powders. A constructed electrokinetic nanogenerator with an effective flow area of ∼0.34 cm2can generate a large current of 91.33 nA under 10-6M NaCl solution with a flow rate of 0.4 ml min-1, corresponding to a maximum power density of 0.45μW m-2. Besides, it shows a good linear relationship between the streaming current and the flow rate, suggesting that it could be used as a self-powered micro-flowmeter. These results provide a convenient way for clean energy harvesting and show a bright future for self-powered systems.Photocatalytic activity of molybdenum disulfide structures with different dimensions (0D, 1D and 2D) functionalized with polymeric carbon nitride (PCN) is presented. MoS2nanotubes (1D), nanoflakes (2D) and quantum dots (0D, QDs) were used, respectively, as co-catalysts of PCN in photocatalytic water splitting reaction to evolve hydrogen. Although, 2D-PCN showed the highest light absorption in visible range and the most enhanced photocurrent response after irradiation with light from 460 to 727 nm, QDs-PCN showed the highest photocatalytic efficiency. The detailed analysis revealed that the superior photocatalytic activity of QDs-PCN in comparison with other structures of MoS2arose from (i) the most effective separation of photoexcited electron-hole pairs, (ii) the most enhanced up-converted photoluminescence (UCPL), (iii) the highest reactivity of electrons in conduction band. Moreover, a narrowed size of QDs affected shorter diffusion path of charge carriers to active reaction sites, higher number of the sites and higher interfacial area between molybdenum disulfide and PCN.Accurate detection of key components plays a vital role in determining cardiovascular diseases in the ECG. In this method, we propose an enhanced T-wave delineation method using the phasor transform. Discrete Wavelet Transform (DWT) and median filters were used to suppress the high-frequency noise and baseline drift during pre-processing. The phasor transform was used to detect and locate the delineation points before and after the T-wave. The proposed method was tested on the QTDB for R-peak, T-peak, and Toffdetection. It achieved both sensitivity (Se%) and positive predictivity (+P%) values of 100 for R-peak detection. In T-peak detection, method shows Se % = 99.46 and +P % = 99.54, respectively. This method has reported Se% = 99.34 and +P% = 99.48 for Toffdetection in the ECG. The achieved results show that the method can be used for cardiac arrhythmia detection related to the morphology of T-wave.Fibroids are benign tumors caused by the proliferation of myometrial smooth muscle cells in the uterus that can lead to symptoms such as abdominal pain, constipation, urinary retention, and infertility. While traditionally thought of as a disease process intrinsic to the uterus, accumulating evidence suggests that fibroid growth may be linked with the systemic vasculature system, although cell-intrinsic factors are certainly of principal importance in their inception. Fibroids are associated with essential hypertension and preeclampsia, as well as atherosclerosis, for reasons that are becoming increasingly elucidated. Factors such as the renin-angiotensin-aldosterone system, estrogen, and endothelial dysfunction all likely play a role in fibroid pathogenesis. In this review, we lay out a framework for reconceptualizing fibroids as a systemic vascular disorder, and discuss how pharmaceutical agents and other interventions targeting the vasculature may aid in the novel treatment of fibroids.Peptidylarginine deiminases (PAD) enzymes were initially characterized in uteri, but since then little research has examined their function in this tissue. PADs post-translationally convert arginine residues in target proteins to citrulline and are highly expressed in ovine caruncle epithelia and ovine uterine luminal epithelial (OLE)-derived cell line. Progesterone (P4) not only maintains the uterine epithelia but also regulates the expression of endometrial genes that code for proteins that comprise the histotroph and are critical during early pregnancy. Given this, we tested whether P4 stimulates PAD-catalyzed histone citrullination to epigenetically regulate expression of the histotroph gene insulin-like growth factor binding protein 1 (IGFBP1) in OLE cells. 100 nM P4 significantly increases IGFBP1 mRNA expression; however, this increase is attenuated by pre-treating OLE cells with 100 nM progesterone receptor antagonist RU486 or 2 µM of a pan-PAD inhibitor. P4 treatment of OLE cells also stimulates citrullination of histone H3 arginine residues 2, 8, and 17 leading to enrichment of the ovine IGFBP1 gene promoter. Since PAD2 nuclear translocation and catalytic activity require calcium, we next investigated whether P4 triggers calcium influx in OLE cells. OLE cells were pre-treated with 10 nM nicardipine, an L-type calcium channel blocker, followed by stimulation with P4. Using fura2-AM imaging, we found that P4 initiates a rapid calcium influx through L-type calcium channels in OLE cells. Furthermore, this influx is necessary for PAD2 nuclear translocation and resulting citrullination of histone H3 arginine residues 2, 8, and 17. Our work suggests that P4 stimulates rapid calcium influx through L-type calcium channels initiating PAD-catalyzed histone citrullination and an increase in IGFBP1 expression. Training loads, injury, and injury prevention in the Para sports population has not been well established. The purpose of this study was to survey elite-level swimming, cycling, and athletic Para sport athletes in the United States who were competing in the 2016 US Paralympic trials to better understand common injuries among athletes in each sport and to determine whether injury prevention programs were being utilized. Cross-sectional, survey study. The 2016 US Paralympic trials for swimming, cycling, and athletics. Athletes who competed in swimming, cycling, and/or athletics at the 2016 US Paralympic trials (N = 144; 83 males and 61 females). Participants completed electronic survey using Qualtrics XM (Qualtrics, Provo, UT) with questions pertaining to average number of hours trained per week, number of cross-training hours performed each week, descriptive information regarding sport-related injuries, pain, whether athletes received treatment for injuries, and descriptive information regarding whether the athletes had participated in an injury prevention program.
